স্টোরেজ লিফট - প্যাটারনোস্টার

Gmatick GmbH Paternoster

1A Gmatick Storage Paternoster (roll rack)

The foil storage Paternoster foils is suitable to use for the storage of all 3D-films, it is used as a high storage at the membrane press or as a space-saving storage solution for the 3D foils.

With our Paternoster you can storage on very small area approximately 2, 4m x 1, 2m a lot of film rolls (up to 32 rolls of a Ø 300 mm). The required film is thus immediately available at the push of button. Our Paternoster are available from 2.8 m up to 6, 0 m as standard Paternoster. Also special solutions are offered by us, please contact us, we will then find the right solution for your storage.

Rcodpfxsff Huws Appsh
As additional equipment we offer center sleeves, a manual cutting station or the full automatic cutting device and we have also ionization solutions available at Gmatick.

• Storage rods ø 42.4 mm
• Sleeves inside Ø max. 82 mm,.
• Load chain as a hollow pin chain with a breaking load of 100 kN,
• Chain pitch is 50 mm hole to hole and this is the raster for the positioning of the mounting foil bars.
• Control with a key switch (dead man) for on / off
• Rotational speed of the chain is approx. 5.5 m / min
• Voltage 400 V, 3N; 50/60 Hz or as USA Version 480V 60Hz
• Mains cable with CEKON plug 16A fuse protection (by the customer) 10A slow blow
• ground load data at least 2, 2 kg / cm²
• Side covering over the entire height of the Paternoster, guards from 2, 2 m above floor to top edge of the Paternoster.
• Requirement for the installation of the Paternoster is a viable, flat and solid floor,
• Floating floors you can’t install a Paternoster. It is forbidden